Macbook Complete A2442/A2779/A2918 Screen - Space Gray - Pulled Original Quality
Get A Direct-Fit 14.2-Inch Complete Display Assembly For Your Macbook Pro A2442, A2779, Or A2918 In Space Gray, Pulled Original Quality For OEM Match And Finish. This Assembly Arrives As A Ready-To-Install Lid With The Mini-led Panel, Space Gray Aluminum Housing, Hinges, Display Flexes, Bezel, And Integrated 1080p Camera The Notch.
Restore Factory Visuals With Liquid Retina XDR Performance Including 3024 × 1964 Resolution At 254 Ppi, ProMotion Up To 120 Hz, P3 Wide Color, True Tone, And An Anti-reflective Coating. Enjoy XDR Brightness With Up To 1600 Nits Peak In HDR, 1000 Nits Sustained Full-screen In HDR, Approximately 600 Nits In SDR, And A 1,000,000:1 Contrast Ratio Delivered By Local Dimming Mini-led Backlighting.
Key Specs For Accurate Color And Smooth Motion
Expect Uniform Backlight, Tight Color Consistency, And Motion That Stays Smooth From 24 Hz To 120 Hz Depending On Content. The Panel Supports True Tone Ambient Light Compensation, Wide Gamut (P3), And Factory Calibration For Gamma And White Balance When Paired With Supported Macos Builds.
The Assembly Uses Original Flex Cabling And Tcon Electronics For Correct Dimming Zone Control And ProMotion Timing. The Camera Cutout Preserves The Native 1080p Facetime Hd Module And Ambient Light Sensor Placement For Reliable Auto-brightness And True Tone Behavior.
Compatibility And Fitment Details For Fast Repairs
Use This Assembly With Macbook Pro 14-Inch Families Identified As A2442, A2779, And A2918 In Space Gray. The Hinge Geometry, Mounting Points, And Flex Layout Match The Original Chassis, Allowing A Straight Swap Without Brackets Or Spacers When you retain the original lower case and clutch cover hardware.</p
The Display Connects Via The Native Board Interfaces With No Adapters, And ProMotion, P3, And True Tone Features Are Retained When Used On Supported Models. The Lid Alignment And Gap To The Palm Rest Match Stock Tolerances When Hinges Are Seated And Torqued Evenly.
What You Receive And Service Notes
You Receive A Pulled Original Quality Complete Screen In Space Gray With The Pre-mounted Panel, Aluminum Lid, Hinges, Camera, Rubber Perimeter Gasket, And Display Flexes Attached. Traces Of Previous Handling May Be Present But Are Kept Minimal To Ensure A Clean Refurbish Outcome On Customer Devices.
Plan Your Bench Workflow With A Pentalobe Bottom Case Opening, Then Torx For Hinge And Internal Brackets, And Final Re-seat Of Antenna And Display Flex Shields Per Model Year Layout. Calibrate Brightness And Color In Macos Displays Settings After Installation, And Run An Hdr Clip To Verify Xdr Peak Levels, Local Dimming Behavior, And 120 Hz ProMotion Operation.
