Macbook Complete A1466 Screen - Silver - OEM Quality For Macbook Air 13-Inch Repairs
Get A Ready-To-Install Display Assembly That Cuts Bench Time And Delivers A Clean, Factory-Like Finish On Every Macbook Air A1466 Job. The Macbook Complete A1466 Screen - Silver - OEM Quality arrives as a full lid assembly so you can swap the entire module rather than chase individual faults.
Expect A Matched Silver Anodized Housing With Pre-Installed 13.-Inch Lcd, Glossy Front Glass, Hinges, Clutch Cover, Facetime Hd Camera, Display Cable, And Wi‑Fi Antennas. The Fit Aligns With Original Screw Points And Bezel Lines, Giving You Consistent Results Across Refurb Batches And Walk Repairs.
Compatibility And Core Specifications
Work Confidently Across The Full A1466 Range Covering Macbook Air 13-Inch Mid 2012, Mid 2013, Early 2014, Early 2015, And 2017. Typical Emc Matches Include 2559, 2632, 2925, And 3178, And The Assembly Is Designed For A1466-Designated Units Only.
Count On A 13.3-Inch Led-Back Panel With A 1440 × 900 Native Resolution At 60 Hz, 16:10 Aspect Ratio, And A Glossy Finish That Mirrors The Original Look. The Module Uses Lvds Signaling With An Integrated Backlight, Includes The 720p Facetime Hd Camera, And Ships As A Silver Top Case With Matching Apple-Style Antenna Windows And Hinge Set.
Installation Notes For A Fast Turnaround
Disconnect The Battery Before You Touch Display Cabling, Then Remove The Bottom Case With A P5 Driver Release The Hinge And Bracket Hardware Using T5 Or T8 Torx Drivers As Required. Lift Out The Old Lid, Route The New Display Cable Cleanly Through The Hinge Channel, Seat The Antenna Leads, And Set Hinge Tension Before Final Tightening To Keep The Aligned And Free From Creaks.
Protect The Panel From Point Pressure During Handling, Test Boot With The Board Exposed, And Check Backlight Uniformity, Camera Feed, Sleep Sensor Response, And Wi‑Fi Reception Before Closing Up. Re-Calibrate Lid Alignment At The Corners, Confirm Even Gap To The Palm Rest, And Wipe The Glass With A Non-Ammonia Cloth For A Dust-Free Hand-Off.
Built For Repair Shops And Refurbishers
Reduce Rework By Re The Entire Display Stack In One Pass Rather Than Mixing Panels, Cables, And Hinges From Different Lots. The Complete Assembly Approach Speeds Intake-To-Exit Times, Standardizes Cosmetic Outcomes On Silver Units, And Helps You Keep Inventory Simple With A Single Sku Covering The Main A1466 Years.
Use This Assembly For Cracked Glass, Flicker Or No-Backlight Cases, Camera Failure Traced To The Lid, Damaged Hinges, Or Dented Top Covers That Prevent A Flush Close. Pair It With Fresh Bottom Case Screws And A New Clutch Cover Gasket If Needed, And You will Have A Consistent, Repeatable Fix That Looks And Functions Like Original.
The screens are covered with a 2-year warranty. The warranty does not cover man-made damage.
