Macbook Complete A1989 / A2159 / A2251 / A2289 Screen - Silver - OEM Quality
This complete 13.3-inch retina display assembly arrives ready to install with the lcd, glass, backlight, camera, hinges, clutch cover, antenna set, and display cables pre-fitted in a silver anodized lid. You get an oem quality fit and finish that matches factory color, brightness uniformity, and hinge torque, making it a dependable swap for cracked panels, flicker, backlight, or cable damage.
The panel delivers 2560 × 1600 resolution at 227 ppi on an ips led backlit display with wide p3 color, 500 nits typical brightness, and a glossy anti-reflective coating. The assembly is true tone capable via the integrated ambient light sensor, and the facetime hd 720p camera is seated in the top bezel with the correct bracket and gasket for clean alignment.
Oem Quality For Reliable Repairs
The glass and lcd are optically laminated for crisp contrast and low internal reflections, and the color calibration targets factory standards for consistent whites and neutral grays across refurb stacks. The hinge set is pre-aligned to reduce lid wobble, and the clutch cover routes the coax lines to maintain stable wifi and bluetooth reception after reassembly.
Connector pads and flexes are reinforced at stress points to handle repeated open-close cycles, and the bezel’s coating is tuned to resist common cleaning solvents used at the bench. Each unit is powered-on tested for pixel integrity, uniform backlighting, camera function, and sleep wake via lid angle sensor.
Compatibility And Core Specifications
This assembly fits 13-inch intel models only: a1989 (2018–2019, macbookpro15,2), a2159 (2019, macbookpro15,4), a2251 (2020, macbookpro16,3), and a2289 (2020, macbookpro16,2). The finish is silver and matches the original silver top case color on these units.
Key specs include a 13.-inch ips lcd, 2560 × 1600 resolution, 16:10 aspect ratio, ~227 ppi, 60 hz refresh, led backlight, p3 wide color, and true tone capability. The assembly includes the facetime hd 720p camera, ambient light sensor, dual hinge set, clutch cover, integrated wifi and bluetooth antennas, pre-installed display and camera flex cables, and perimeter seal.
Installation And Testing Notes For Repair Shops
You can transfer over the original hinge screws and antenna brackets as needed mount the display, route the coax and flex lines cleanly through the hinge channel, and torque to spec to prevent creaks or lid drift. You should avoid pinching the display flex where it bends near the hinge and confirm the foam pads sit flat against the frame to stop light leaks.
You should run a final checklist after power on: verify full brightness without flicker, check color uniformity against a white test image, open facetime to confirm camera focus, toggle true tone and auto brightness in settings to validate the ambient light sensor, test sleep wake by closing and opening the lid, and confirm steady wifi and bluetooth signal with antennas seated.
The screens are covered with a 2-year warranty. The warranty does not cover man-made damage.
