Macbook Complete A1706 / A1708 Screen - Silver - OEM Quality
This complete silver display assembly gets your 13 inch Macbook Pro A1706 or A1708 back on the bench and out the door fast. The assembly includes the 13.3 inch ips retina lcd, front glass, aluminum lid, hinges, clutch cover, display cable, camera cable, bezel gasket, and integrated antennas, all pre-aligned and ready to fit.
The panel delivers a native resolution of 2560 x1600 at 60 hz with a glossy, anti‑reflective surface. Typical brightness is up to 500 nits with a wide p3 color gamut and a 1000:1 contrast ratio for consistent grayscale and color accuracy across refurb runs. The unit integrates a 720p facetime hd camera and ambient light sensor in the top housing. The finish matches the original silver color, so you maintain factory look on mixed-fleet repairs.
Compatibility And Key Technical Data
Compatibility covers macbook pro 13 inch 2016 and 2017 models only, including a1706 with touch bar and a1708 without touch bar. The assembly is not cross compatible with later 13 inch models such as a1989, a2159, a2251, or a2289. The hinge geometry, antenna layout, and display cable pinout are matched to a1706 and a1708 logic boards to avoid image artifacts or no backlight issues.
Core specifications include a tcon integrated lcd, wide viewing angles, led backlight, 227 ppi pixel density, single stream edp signaling via the pre-installed flex. The camera bracket and microphone passthrough are in place, and the lid houses the dual wifi antennas as per the original design. The assembly ships with protective transport films and hinge screws pre-set for tension, so you only align, torque, and test. The part is oem quality for reliable color uniformity, low mura, and minimal backlight bleed within accepted factory tolerances.
Repair Workflow And Installation Notes
You save time because there is no panel bonding, lid tr, or hinge press work required. You disconnect the battery, remove the lower case, detach the display flexes from the logic board, release the hinge screws, lift the old lid, seat the new assembly, align the hinge caps to the clutch cover, torque evenly, and reconnect. You then perform a basic boot test for image, keyboard backlight passthrough, camera function, sleep wake on lid angle, and wifi signal strength.
You reduce callbacks by cleaning old thread locker from the chassis standoffs, applying fresh medium thread locker to hinge screws, verifying even lid gaps before final torque. You avoid mixing with other generations and you confirm the silver color match when refurbishing paired top cases. You can run an optional color profile check if your workflow includes display calibration, though no firmware pairing or true tone sync is required on a1706 or a1708.
The screens are covered with a 2-year warranty. The warranty does not cover man-made damage.
