Macbook Air A2681 Complete Screen In Silver
Get A Ready-To-Install Macbook Complete A2681 Screen - Silver - OEM Quality Built For Fast, Predictable Repairs. This Is A Full Lid Assembly With Preinstalled Lcd, Backlight, Bezel, Hinges, And Display Flex Cables, So You Swap The Entire Top And Restore Factory Fit And Alignment. The Silver Anodized Aluminum Matches The Original Finish, And The Thin-Bezel Design With Notch Preserves The Clean Look Of The 136-Inch Macbook Air.
Expect Accurate Color, Stable Brightness, And Smooth Motion That Align With Apple’s Published Characteristics For A2681. The Assembly Arrives Clean-Room Packaged, Film Protected, And Bench Tested For Pixel Integrity, Backlight Uniformity, And Hinge Tension, Helping You Cut Rework And Keep Turnaround Times Short.
A2681 Display Specifications And Build
The Panel Measures 13.6 Inches Diagonally And Delivers 2560 × 1664 Resolution At60 Hz With An Ips Lcd And Led Backlight. Typical Brightness Is 500 Nits With Wide Color Support For P3 And True Tone Compatibility When Paired With A Macbook Air A2681. The Surface Is Glossy With An Anti-Reflective Coating, And The Notch Area Supports The 1080p Facetime Hd Camera Used On This Model. Color Depth, Gamma, And White Point Are Tuned To Match The Original Viewing Experience.
The Assembly Includes The Silver Aluminum Lid, Factory-Laminated Cover Glass, Integrated Back Driver, Preinstalled Hinges, And Model-Specific Display Flex Cables. The Mechanical Geometry Matches The Original Housing, Allowing Precise Closure, Even Bezel Gaps, And Reliable Sleep-Wake Magnet Alignment.
Installation And Compatibility For Repair Shops
This Screen Is Compatible With Macbook Air A2681 13.6-Inch (M2, 2022–2023). You Should Confirm “A2681” On The Lower Case Before Ordering And Note That It Is Not Cross-Compatible With A2337 Or Air Models. The Assembly Drops In Without Micro-Soldering And Reuses The Original Mounting Hardware From The Chassis.
Disconnect The Battery Before Handling Display Connectors And Work With Esd Precautions. Remove Bottom Case Screws, Isolate The Battery, Release The Display Flex, Loosen Hinge Clamps, And Lift The Old Lid. Fit The New Assembly, Center The Hinges, Tighten Evenly To Avoid Warp, Reconnect Flex Cables, And Reassemble. You May Need To Transfer Cosmetic Rubber Gaskets Or Small Brackets From Old Lid Depending On Your Configuration. A P5 Pentalobe, T3 Or T5 Torx, And T8 Torx Driver With A Nylon Spudger Are Typically Required. After Boot, Check Brightness Range, True Tone In Settings, Camera Function, Sleep-Wake On Lid Close, And Panel Uniformity.
OEM Quality You Can Trust
OEM Quality Means The Panel, Glass, Coatings, And Mechanics Are Built To Original Specifications For Fit, Color, And Durability. Each Unit Undergoes Functional Testing For Dead Pixels, Light Bleed, Flicker, Color Shift, Connector Integrity, Bezel Alignment, And Hinge Friction, So You Deliver Consistent Results To Your Clients.
This Assembly Suits Retail Repair Desks, Corporate Fleet Service, Refurb Lines, And Insurance Jobs Where Predictable Parts And Minimal Bench Time Matter. You Get A Consistent Silver Finish, Drop-In Compatibility With A2681, And A Stable Supply Option That Keeps Your Workflow Moving Without Guesswork.
The screens are covered with a 2-year warranty. The warranty does not cover man-made damage.
