Macbook Complete A1990 Screen - Silver - OEM Quality
This is a complete, ready‑to‑install display assembly for the MacBook Pro 15‑inch A1990 in silver, built to OEM quality for reliable fit and finish. It arrives fully assembled with the LCD panel, cover glass, back lid, hinges, antenna array, display cables, camera assembly, and rubber gasket pre‑fitted, so you can swap the unit and return the device to service quickly.
The panel is a 154‑inch retina IPS LCD at 2880 × 1800 resolution and 220 ppi, with P3 wide color support, up to 500 nits brightness, and a glossy surface with anti‑reflective coating. It runs at 60 Hz refresh rate, supports True Tone when paired with a compatible logic board, and delivers uniform backlight, accurate gamma, and tight color delta targets expected from OEM‑grade screens.
Compatibility And Identification For A1990 2018–2019
Compatibility is specific to MacBook Pro 15‑inch A1990 models from 2018 and 2019 with Touch Bar in the silver finish. Supported model identifiers include MacBookPro15,1 and MacBookPro15,3, and you can confirm A1990 on the bottom case or by checking the original serial’s year configuration.
This assembly is not cross‑compatible with earlier 15‑inch A1707 units from 2016–2017 or with any 16‑inch models. The hinge geometry, antenna bar layout, ambient light and camera flex positioning and cable pitch are matched to A1990 tolerances to ensure correct alignment and lid closing pressure.
Assembly Contents And Build Details
The package includes the silver anodized aluminum top case, laminated retina LCD, FaceTime HD camera module, dual Wi‑Fi and Bluetooth antenna set, left and right hinges with mounting brackets, integrated display flex cables, clutch cover, and perimeter rubber seal. Pre‑installed components reduce handling of delicate flexes and minimize dust ingress during installation.
Optical characteristics meet original specifications for contrast viewing angles, and white point, with factory testing for dead pixels, line defects, and backlight uniformity. The anti‑reflective coating is applied to OEM standards for glare control, and the assembly ships with protective transport films to keep the glass and finish clean until final fitment.
Installation And Service Notes
Installation requires standard Mac service tools, including P5 pentalobe for the bottom case and T3 and T5 Torx drivers for hinge and antenna bracket hardware, along with a spudger and ESD. You should disconnect the battery before unplugging or connecting the display cable, seat hinges loosely, align the lid, then tighten evenly to avoid torsion on the clutch area.
No pairing or firmware provisioning is needed for display functionality, and True Tone will operate automatically on supported systems after boot. You should run a white‑screen, color bars, and backlight gradient test before reassembly, verify ambient light and camera operation, and confirm even gap lines along the hinge cover. You should reuse original screws where possible, avoid over‑torque, and keep the cable path clear to prevent pinch damage when securing the antenna bar.
The screens are covered with a 2-year warranty. The warranty does not cover man-made damage.
