Macbook Complete A2338 Screen - Space Grey - OEM Quality Replacement
Get a ready-to-install top case assembly for fast bench turnaround and consistent results. The Macbook Complete A2338 Screen - Space Grey - OEM Quality includes the 13.3‑inch retina lcd panel, front glass, space grey aluminum lid, hinges, display cable, wifi antenna set, clutch cover, and facetime hd camera pre-fitted. It supports true tone, wide color (p3), and 500 nits typical brightness at hz, delivering the same visual experience your customers expect on a macbook pro a2338.
Each unit is built to oem standards for fit, finish, and color accuracy, reducing rework and aftersales issues. The anti‑reflective coating and precisely aligned hinge geometry help eliminate light bleed and lid wobble, while factory calibration provides stable white point and uniform luminance across the panel.
Technical Specifications For Macbook Pro A2338 Display Assembly
Display size is 13.3 inches with an ips retina panel at 2560 × 1600 resolution (227 ppi) and a 16:10 aspect ratio. Typical brightness is 500 nits with wide color (p3), srgb 100% coverage, and a 60 hz refresh rate. Contrast ratio is approximately 1000:1 with a low‑glare, anti‑reflective finish. The assembly integrates the facetime hd 720p camera and ambient features for true tone, and arrives with hinges, antenna modules, and display flex pre-installed. The unit is space grey, matches original anodization, and is supplied as a full lid assembly requiring no panel bonding or glass separation.
Compatibility, Installation Notes, And Use Cases
Compatibility covers macbook pro 13‑inch a2338 models produced in 2020–2022 in space grey. It is not cross‑compatible with earlier 13‑inch units such as a1989 or a2159. No programming or pairing is required, and true tone functions when supported by the logic board and macos. Typical use cases include cracked or delamin glass, liquid‑damaged panels, failed backlights, ghosting or image retention, hinge damage causing lid misalignment, and antenna faults housed in the original lid.
Installation is straightforward for experienced technicians. You will remove the bottom case with a p5 pentalobe driver, isolate the battery, release the display cable and camera/antenna connections, and swap the complete lid. You will torque hinge screws evenly to maintain lid alignment, reconnect, then run a display and camera test. You should transfer only cosmetic items if present on the old unit, this assembly includes hinges and cables. You should perform a final check for pixel defects, uniform backlight, true tone operation, camera focus, and wifi signal strength before closing the case.
The screens are covered with a 2-year warranty. The warranty does not cover man-made damage.
