MacBook Battery A1496 - OEM Quality For MacBook Air 13-Inch (2013–2017)
Choose MacBook Battery A1496 - OEM Quality when you need a direct-fit pack that matches original performance and communicates correctly with macOS. This unit is built for the 13-inch MacBook Air A1466 from mid‑2013 through 2017, covering model identifiers MacBookAir6,2 and MacBookAir7,2. The assembly aligns with factory screw points and uses the native battery, so you get a clean swap with no adapters.
Expect stable runtimes thanks to a 7.6 v nominal output, 54.4 wh energy rating, and approximately 7150 mah capacity using lithium‑polymer cells. The integrated fuel gauge and protection circuitry report charge, cycle count, and temperature accurately to the system, enabling proper power management and sleep behavior. The pack is balanced for low self‑discharge during storage and consistent discharge curves under typical office, classroom, and field service workloads.
Key Technical Data And Compatibility
Battery model: A1496. Chemistry: lithium‑polymer. Nominal voltage: 7.6 v. Energy: 54.4 wh. Capacity: ~7150 mah. Interface: native MacBook Air battery flex with onboard management ic. Form factor: 13‑inch MacBook Air pack with multi‑section cells in a single lower‑case assembly. Compatibility: MacBook Air 13‑inch A1466 (mid‑2013, early‑2014, early‑2015, 2017), identifiers MacBookAir6,2 and MacBookAir 7,2. Fitment notes: not compatible with A1405 or earlier 13‑inch MacBook Air revisions.
Performance characteristics include steady voltage delivery across common workload spikes, accurate remaining‑time estimates after calibration, and thermal safeguards for overcharge, overcurrent, and short‑circuit events. The pack is designed for everyday deployment in refurbishing lines and repair benches, supporting frequent charge cycles, office docking, and mobile use without sudden shutdowns or drift in percentage reporting when the system is and calibrated.
Installation Guidance And Service Tips For Repair Shops
Power the machine down, unplug the adapter, and discharge below 25% before opening to reduce stress on the pack. Remove the bottom case with a P5 pentalobe driver, then release the battery with a T5 torx driver and disconnect the flex before lifting the assembly. Seat the new A1496, reconnect the flex firmly, and reinstall screws using light, even torque with no threadlocker. Inspect for trapped cables, clean dust from the fans and sink area, and verify that the bottom case sits flush with no cell contact.
After first boot, perform a calibration cycle for best fuel‑gauge accuracy. Charge to 100%, keep it connected for two additional hours, use the MacBook Air on battery until it reaches about 5–10%, let it rest for a short period, then recharge to 100% without interruption. Reset the smc on Intel units if percentage reporting seems inconsistent by holding shift + control + option and the power key for ten seconds with the machine off, then releasing and powering on. Store spare packs around half charge in a cool, dry place and avoid prolonged heat exposure to preserve capacity over time.
The battery is covered with a 1-year product warranty. The warranty does not cover man-made damage or wear and tear. To be used with MacBook model number: A1369, A1466
