Complete Screen For MacBook Air A2179 In Gold
Macbook Complete A2179 Screen - Gold - OEM Quality delivers a ready-to-install top assembly for the 13.3-inch MacBook Air A2179 (2020). It restores factory visual performance and the color-matched gold finish in a single swap designed for repair benches and refurbishment lines.
The assembly is built to OEM standards and arrives pre-aligned for precise fit. It includes the bonded retina lcd and cover glass, the gold anodized aluminum, the display cable, the facetime hd camera module, and the hinge set, giving you a clean replacement without panel bonding or bezel rework.
Key Technical Data And Build
The display is a 13.3-inch ips retina panel with a native resolution of 2560 × 1600 at 227 ppi and a 16:10 aspect ratio. It uses an led backlight, runs at 60 Hz, offers wide viewing angles, and features a glossy surface with anti-reflective coating for improved readability under ambient light. Color comes factory calibrated, gamma is consistent across the panel, and backlight uniformity is checked to reduce mura and tint shift. The integrated facetime hd camera sits in the upper bezel, and the assembly supports true tone when paired with a logic board that provides it.
Compatibility is exclusive to MacBook Air 13-inch A2179. It does not fit A1932 or A2337 due to different cable routing, hinge geometry, and bracket positions. The hinges are matched to the A2179 chassis for proper clutch tension and even lid, and the antenna channels and cable guides follow the original layout to keep the clutch cover area tidy during reassembly.
Fast Repair Workflow And Fitment Tips
Installation follows a standard top-lid swap for the A2179. You disconnect the battery, remove the old hinge screws while supporting the lid, seat the new assembly, route the display cable cleanly through the guides, and tighten the hinge screws evenly from the center outward to prevent chassis twist. You then reconnect and secure the display cable, reinstall the clutch cover, and gap symmetry along the palm rest and corners.
Post-install checks should include pixel mapping at multiple backgrounds, backlight step response, sleep-wake on lid open and close, camera preview, and true tone toggle if supported by the board. You should confirm even hinge resistance across the opening range, verify that the lid sits flush when closed, and run a brief thermal soak to rule out pressure marks or light bleed.
Reliability, Testing, And Packaging
Each unit is inspected for dead pixels, line defects, inclusion, and backlight clouding, with color and luminance measured against OEM tolerances. Hinge alignment is checked for parallelism and torque balance, camera focus is verified, and the bezel and lid cosmetics are screened to keep the gold finish consistent across batches.
The screen ships with protective films on the cover glass and camera window, foam edge guards around the lid, and an esd-safe inner bag inside a rigid carton. The packaging is optimized for workshop inventory and parcel shipments across Europe, so you can stock spares and roll out dependable A2179 repairs with minimal rework time.
The screens are covered with a 2-year warranty. The warranty does not cover man-made damage.
