MacBook A2941 / A3114 Starlight Screen Assembly
The MacBook Complete A2941 / A3114 Screen - Starlight - OEM Quality is a ready-to-install display lid that restores factory visuals and finish in one swap. The unit arrives fully built as a complete top case assembly, enabling fast turnaround for busy benches and consistent results across high-volume workflows.
The Starlight anodized finish matches original MacBook color tone and texture for a seamless exterior repair. The assembly is designed for exact on the specified MacBook models, with precise hinge geometry and bracket alignment to keep lid gaps, clutch tension, and opening angles within original tolerances.
OEM Quality Components And Finish
The panel delivers OEM-level luminance uniformity, color consistency, and viewing stability, with edge-to-edge lamination that preserves the crisp glass surface and tight black levels you expect from an original part. Each unit is pixel-checked and inspected for backlight bleed, tint variance, and line artifacts to reduce rework and callbacks.
The outer housing, bezel, and hinge set are factory-assembled to minimize handling of fragile flexes during installation. The integrated camera module and sensor window are pre-aligned behind the bezel to maintain proper focus and exposure behavior after installation, supporting features that rely on ambient detection and automatic adjustments.
Compatibility And Connectors
This assembly is compatible with MacBook models identified as A2941 and A3114 in the Starlight color variant. The display flex and hinge hardware follow the original routing and mounting footprint for these models, allowing a direct without frame modifications or custom shims.
The connector layout mirrors the original logic board interfaces used by A2941 and A3114, allowing you to seat the primary display flex and hinge screws in the stock locations. The part is not intended for other MacBook identifiers, and mixing assemblies across model numbers can cause fit and signal issues.
Installation And Service Guidance For Repair Shops
Begin by powering down the MacBook, disconnecting the battery, and removing the bottom case to access hinge and display connectors. Support the when releasing hinge screws, transfer any model-specific brackets if required, route the flex in the factory channel, and tighten hinge screws gradually from center out to maintain even tension and alignment.
Complete a post-repair check that covers boot image, uniform backlight levels on white and gray screens, full brightness range, sleep and wake on lid movement, camera preview, and sensor-driven adjustments. Ship or hand back the device with a protective film on the glass and outer housing to prevent scuffs during final handling, and store spares in the included protective packaging to keep the Starlight finish free from abrasions.
The screens are covered with a 2-year warranty. The warranty does not cover man-made damage.
