iPhone 14 Pro - Black - Pulled Diagnostic Screen For Fast Triage
Get a bench‑ready original iPhone 14 Pro - Black - Pulled Diagnostic Screen that lets you isolate faults and quote repairs in minutes. This genuine pulled panel is function tested for display output and touch response, making it ideal for quick swaps during board diagnostics, intake checks, and post‑repair verification. The screen fits model iPhone 14 Pro and matches model id A2890, ensuring the correct connector layout, frame geometry, and Island alignment.
Use this assembly when you need a known‑good display for rapid A/B testing, ruling out display‑side faults, or confirming GPU, PMIC, or connector‑level issues on the logic board. True Tone is supported and can be retained by transferring the original display data with a programmer or service tool. Face ID remains paired to the device and is not affected by swapping the screen. The ear speaker and sensor array are not included and should be transferred from the device to maintain proximity and ambient light functions.
Key Display Specs You Can Rely On
Enjoy the native performance of the iPhone 14 Pro panel with a 6.1 inch Super Retina XDR LTPO OLED at 2556 × 1179 resolution and 460 ppi. Experience adaptive ProMotion with a 1–120 Hz refresh range, Always‑On support, wide color (P3), True Tone, Haptic Touch, and a 2,000,000:1 contrast ratio for precise color and deep blacks during testing.
Count on high brightness with 1000 nits typical full‑screen, 1600 nits peak HDR, and up to 2000 nits peak outdoor brightness. Benefit from HDR10 and Dolby Vision support when validating media playback and color uniformity. The assembly includes the integrated OLED panel, touch digitizer, display driver IC, and front glass with Ceramic Shield, providing a stable baseline for repeatable test results.
Bench Workflow, Compatibility, And Install Notes
Connect the iPhone 14 Pro - Black - Pulled Diagnostic Screen to a known‑ logic board and run a fast QC routine: full white, red, green, blue, and black screens for pixel defects, a multi‑touch grid sweep, brightness ramp, and color shift at angles. Check for uniformity, flicker, or lines, then validate Always‑On, True Tone after data transfer, and HDR playback. Use this panel for temporary fits without final sealing while you confirm faults, then reassemble with fresh adhesive once the repair path is set.
Follow standard iPhone 14 Pro practices during install. Transfer the ear speaker and array to retain proximity and ambient light performance. Expect a possible “unknown part” notice in iOS when the assembly is not the device’s original pair, which does not affect function. Use ESD precautions, control heat when separating adhesive, avoid pinch on the flexes near the top edge, and replace the perimeter gasket before a permanent close. Confirm fit for iPhone 14 Pro only, model id A2890, and do not use on iPhone 14 Pro Max or other variants.
