iPhone 15 Battery - High Capacity - OEM Quality
Upgrade Runtime And Cut Comebacks With A Drop-In Replacement Built For iPhone 15, Model Id A3090. Enjoy A High Capacity Cell For Longer Daily Use Than A Standard Pack, Matched With OEM Quality Materials, A Precise Flex Layout, And A Smart Gas-Gauge That Reports Accurately In Ios Battery Health. Expect A 0-Cycle Unit With Tight Impedance Control For Stable Peak Current During Navigation, Video, And 5g Loads Count On Consistent Fitment, Pre-Applied Pull Tabs For Clean Removal Next Service, And Adhesive Ready For Direct Install.
Rely On True Compatibility With Ios 17 Battery Metrics And Charge Management. Use It For Repairs, Bulk Refurb Projects, And Warranty Swaps Where Capacity And Consistency Matter. Fit Is Limited To iPhone 15 And Model Id A3090, And It Does Not Fit iPhone 15 Plus, iPhone 15 Pro, Or iPhone 15 Pro Max.
OEM Quality Build And Safety
Trust A Lithium-Ion Polymer Cell With Low Internal Resistance And A Protection Circuit Supporting Overcharge, Over-Discharge, Over-Current, And Short-Circuit Safeguards. Benefit From A Calibrated Ntc Thermistor And A Gas-Gauge Ic That Keeps Health Readings Steady Over Time. Get A Factory-Fresh Pack With Date Coding And Traceability For Service Records And Batch Control.
Store And Ship With Confidence Under Un 38.3 Standards With Ce And RoHS Compliance. Maintain Stock At –50 Percent State Of Charge, Keep At 15–25°c, And Avoid Deep Discharge In Storage To Preserve Capacity. Remove And Recycle Spent Cells Following Local WEEE Rules.
Technical Data And Compatibility
Work With A Nominal Voltage Of 3.85 V And A Charge Limit Voltage Of 4.35 V, Matching Apple Charging Profiles. Target A Cycle Life Of 500+ Cycles To 80 Percent Capacity Retention Under Normal Use. Use A Form Factor And Connector Footprint That Mirrors Original For A Clean Refit With The Existing Brackets And Shields. Expect High Capacity Performance That Extends Runtime Versus A Standard iPhone 15 Pack While Maintaining Stable Cold And Warm-Load Behavior.
Fit Is For iPhone 15 With Model Id A3090 Only. Pairing Is Not Required For Operation, And Ios Battery Health Will Read From The Onboard Gauge. Note That Ios May Show An Important Battery Message After Third-Party Replacement, And Device Functionality Remains Unaffected.
Repair And Installation Notesh2>
Power Down, Remove The P2 Pentalobe Screws, And Open From The Bottom Edge With Heat And Suction. Disconnect The Battery First, Transfer Any Shields And Brackets, Seat The New Pack, And Route The Flex Without Tension. Install With Fresh Perimeter Adhesive And Align For Even Pressure On The Back Housing. Use Y000 For Internal Screws And A Standoff Driver Where Required, And Finish With The Pull Tabs Positioned For Future Serviceability.
Calibrate After Install By Charging To 100 Percent, Resting For 30 Minutes, Then Discharging To 5–10 Percent And Recharging To Full. Verify Thermal Readings And Health Percentage In Settings Before Return To Customer. Recommend This Unit For Heavy-Use Devices In Field Service, Corporate Fleets, Delivery Apps, And Retail POS Where Longer Runtime And Reliable Health Reporting Reduce Support Calls.
