iPhone 13 Pro - Black - Pulled Diagnostic Screen
This Is A Pulled Diagnostic Display Assembly For iPhone 13 Pro That Delivers The Correct Look, Feel, And Motion Performance You expect On Bench And In Refurb Lines. It Arrives In Black And Is Designed For Fast Swap‑In Testing Or As A High‑grade Replacement Where You need A Reliable Panel With Accurate Color And Smooth Scrolling.
This Screen Fits Model iPhone 13 Pro Only And Matches Model Id A2638. It Is For Logic Board Isolation, Post‑Repair Verification, And Turnaround‑focused Refurbishment Where A Known‑Good Display Saves Time. You Can Use It To Confirm Touch And Image Output, To Finalize QC On Rebuilt Units, Or To Replace Broken Glass And Panels While Retaining Face Id By Transferring The Original Sensor Flex.
Technical Data And Compatibility
This Display Uses A 6.1‑Inch Oled Super Retina Xdr Panel At 2532 × 1170 Resolution For 460 Ppi Sharpness. It Supports Promotion Up To 120 Hz For Variable Refresh, Delivers Wide Color (P3), And Supports True Tone When You Transfer The Original Calibration Data With A Programmer. Typical Max Brightness Reaches Around 1000 Nits With Peak Hdr Up To Approximately 1200 Nits, And The Panel Features A Fingerprint‑Resistant Oleophobic Coating For Daily Use. Touch Response Is Fast And Consistent Across The Full Active Area, And Contrast Is Deep With An Approximate 2,000,000:1 Ratio Characteristic Of Oled.
Connector Layout Matches iPhone 13 Pro With Two Display Flex Connectors. This Unit Fits iPhone 13 Pro Only, Model Id A2638, And Is Not Compatible With iPhone 13, iPhone 13 Mini, Or iPhone 13 Pro Max. Color Is Black To Match The Factory Bezel Appearance Used Across iPhone 13 Pro Front Assemblies.
Installation And Repair Notes
You Will Transfer The Original Ear Speaker And Front Sensor Flex From The Device To Keep Face Id Functionality, Since Assembly Is Paired To The Logic Board. You Should Also Move Over Any Brackets, Meshes, And Camera Locators As Required. You Will Preserve True Tone By Copying The Original Display’s Eeprom Data To This Screen With A Compatible Programmer Before Final Seal‑Up.
You Should Open The Device With Controlled Heat, Replace The Perimeter Adhesive Gasket, And Test Image, Brightness, Touch, And Proximity Before Final Closure. You Will Want P2 Pentalobe And Y000 Drivers, A Standoff Bit, Esd‑Safe Tools, And Plastic Picks For A Clean Separation. You Should Power‑Cycle And Run A Quick Functional Check In Diagnostics Or Your Preferred App Suite To Confirm Performance After Installation.
