Macbook A2991 Complete Screen For Fast, Reliable Replacements
The Macbook Complete A2991 Screen - Black - OEM Quality arrives as a full top-lid assembly designed for quick swaps and minimal teardown time. It comes preinstalled with the lcd panel, cover glass, bezel, hinges, and display flexes, so you replace the entire clamshell in one pass and avoid risky panel-only work.
Compatibility is limited to units labeled A2991, as shown on the bottom case or in “about mac.” Use it to resolve cracked glass, no image, vertical lines, pressure marks, flicker, or backlight failure caused by impact or liquid ingress into the lid. Each assembly is qc-checked for pixel integrity, uniform brightness, clean lamination, correct hinge tension, and perfectly aligned lid geometry to match the original fit and finish.
What You Get In The Complete Assembly
This is a color-matched black display assembly that includes the laminated lcd and cover glass, the aluminum top housing, the left and right hinge set, the factory-routed display flex cables, the camera window and bracket, and the perimeter gasket. Hinges are installed to speed up turnaround; you only transfer hinge screws or antenna brackets if your workflow requires it.
The panel and housing are OEM quality, built to mirror original tolerances for gap, bezel line, and clutch cover alignment. The assembly uses the native eDP display interface and A2991-specific flex pinout, so there is no adapter or remap needed. True tone and ambient light behavior are supported when you migrate the display configuration data from the original with your preferred copier or programmer. The surface is factory-laminated to keep dust out of the optical stack and maintain crisp contrast across the full viewing area.
Installation And Calibration Tips For Repair Shops
Always disconnect the battery before handling the display flex to protect the backlight and display power rails. Test the new assembly on the bench before full reassembly: check image, backlight, camera preview, sleep/wake with lid magnet, and panel uniformity on gray, white, red, green, and blue test patterns. the flex without twists, seat connectors fully, and tighten hinge screws in small, even increments to prevent lid skew and creaks. Use low-strength threadlocker on hinge screws if the original had it, and verify clutch friction so the lid holds position without wobble.
Preserve color characteristics by transferring panel data from the original display if your tooling supports it, then verify true tone toggles correctly in settings. After final assembly, confirm keyboard deck alignment, run a short burn-in at medium brightness to check for light bleed or mura, and document the serial of new lid for your records. Typical swap time is 30–60 minutes with proper fixtures, and the complete assembly approach keeps rework rates low while restoring factory-grade appearance on A2991 units.
The screens are covered with a 2-year warranty. The warranty does not cover man-made damage.
