iPhone 13 - FHD Quality JK Inc - Moveable IC
This display assembly is built for fast, predictable repairs on iPhone 13 with FHD quality from JK and an incell touch structure for crisp visuals and responsive input. You get a stable lcd panel with integrated touch that reduces thickness and weight compared to cell-on-glass constructions, while keeping color consistency and smooth scrolling at 60 hz.
The front glass features an oleophobic coating for easier cleaning and a hard surface that resists everyday marks from handling during refurbishment. The assembly arrives with a robust metal backplate and precise black frame borders, giving you tight alignment to the chassis and reliable bonding with standard frame adhesive gaskets.
Moveable IC For Easier Fitting And Lower Return Risk
>The moveable ic on the display flex lets you shift the chip position to clear brackets or standoffs in different housing batches, which helps prevent pressure points and random line artifacts after reassembly. You can seat the ic under the shield at a safer angle, reduce stress on the flex, and avoid unnecessary trimming inside the frame.
Touch response remains consistent across the panel with stable tracking for multi‑touch gestures and keyboard input. Optical bonding delivers solid contrast and uniform backlight diffusion, so you avoid patchy brightness and keep content readable for end users indoors and in daylight conditions.
Key Technical Data For Workshop Planning
Compatibility covers iPhone 13 6.1 inch models A2482, A2631, A2633, A2634, and A2635. The panel is an ips lcd with incell touch, 60 hz refresh, and an fhd‑class pixel matrix tuned for iOS scaling. The backlight is led driven and designed for steady brightness without flicker, and the polarizer gives good viewing angles for typical daily use. The cover glass includes an oleophobic layer, the bezel is black, and the assembly uses a cold‑pressed frame with a metal backplate for thermal stability.
True tone can be retained by transferring display data with a programmer, and auto brightness works when you move the original ear speaker and sensor module The ear speaker and sensor flex are not included and must be reused from the device to keep Face ID functionality. Each unit is function tested for touch and display before packing, and is ready for pre‑installation checks on your bench.
Installation Notes For Consistent Resultsh2>
You should power down the device, disconnect the battery, and dry fit the panel before sealing to verify touch, color uniformity, and face id sensor alignment. You can position the moveable ic so it clears the bracket, add a small adhesive tab to secure it, and avoid flex strain when closing the display.
You should transfer the ear speaker and sensor module carefully, keep the sensor lenses clean, and install a new adhesive gasket for perimeter sealing. You can finish by writing back the original display data to restore true tone, perform a full functional test, and then close with correct screw lengths to prevent board damage.
